Check Out These Cool Pics of a 3D Printed 5-Speed Transmission

March 14, 2015 Uncategorized

This was found on Thingiverse.

This is the 5 speed transmission that comes bolted to the back of a 22RE. This is the 4WD version of the transmission so it has a mounting surface to bolt a transfer case to. I’ll work to get a 2wd housing designed up, since the only difference is the rear section of the transmission. The transfer case will be the next thing I will upload

Fully working. All 5 speeds plus reverse. It uses a good amount of 3mm rod and 623zz bearings. M2.5 x 5mm set screws and nuts were used due to the small size of some of the parts.

transmission3 transmission4 transmission2

About Cameron Naramore

Cameron, Senior Staff Writer, is a technology enthusiast that can better write about 3D printing than he can ride a bike. His interest in 3D printing is mostly driven by his desire to become a cyborg. He enjoys philosophical conversation and is also fond of poetry and Star Trek. Connect with him on Google+.